Disassembly Of Rear Axle - Cub Cadet 8354 Service Manual

CHAPTER 5 8354/8404

4.2 DISASSEMBLY OF REAR AXLE

1. Using bearing puller, pull out ball (roller) bearing
(2) from the rear axle (1).
2. Straighten cocking of 55 (60) gear (3) locking nut
(4).
3. Disassemble 55 (60) gear, spacer barrel (5), and
spacer plate (6).
4. Loosen attaching bolt (8) of rear axle case cover (7)
and pull out axle and cover from axle case in a body.
5. Using bearing puller, pull out rear axle case cover
(7) and bearing (9) from axle.
Sect. Spec.
M10
Lock bolt
(Reassembling)
• Apply grease to the O-ring (10) and oil seal (11)
contacted surface.
• Take care of assembly direction and method for oil seal.
A. Oil Seal Assembly Method
• Disconnect inner and outer wheels and assemble
inner wheel into axle and outer wheel into cover to
prevent damage using fixture.
• Replace lock nut, tighten and perform locking firmly.
Sect. Spec.
Lock nut M39
M45
• Make sure assembly direction of roller bearing
(NE207E) is correct.
- See the following figure (Applicable model: 8404)
5-8
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Tightening torque
48.0 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.4 ~ 41.2 lbf·ft
Tightening torque
196 ~ 245 N·m
20 ~ 25 kgf·m
144.6 ~ 180.8 lbf·ft
(1) Rear Axle
(2) Ball (Roller) Bearing
(3) 55 (60) Gear
(4) Nut (10) O-Ring
(5) Spacer Barrel (11) Oil Seal
(6) Spacer Plate
(1) Inner Wheel
(2) Rear Axle Case Cover (4) Outer Wheel
615W507A
(7) Rear Axle Case Cover
(8) Bolt
(9) Ball Bearing
615W508A
(3) Rear Axle
615W509A
D615-W02 May-2003