Cub Cadet 8354 Service Manual page 148

CHAPTER 4 8354/8404
2. With synchronizer ring contacted with taper cone of
the opposite gear, measure the clearance between
synchro spline and opposite gear spline using
clearance gage.
Sect. Specified
Clearance
1.35 ~ 1.65 mm
between
0.053 ~ 0.065 in.
synchro and
gear spline (A)
3. Apply O.D. of taper cone in gear with thin red lead,
tighten synchronizer ring firmly, and check for con-
tacted state.
Sect. Specified
Contact rate More than
between
80%
synchronizer
ring and gear
taper
E. Checking Clutch disc, Clutch plate, brake
disc for wear state
1. Using venire calipers, measure the thickness of
clutch disc, clutch plate and brake plate.
2. If exceeds allowable tolerance, replace it.
Sect. Specified
Thickness of
2.10 ~ 2.30 mm
clutch disc
0.083 ~ 0.091 in.
Thickness of 1.45 ~ 1.55 mm
clutch plate
0.057 ~ 0.061 in.
2.90 ~ 3.10 mm
Thickness of
brake plate
0.114 ~ 0.122 in.
4-44
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Limit
0.5 mm
0.02 in.
Limit
More than
80%
Allowable Limit
2.05 mm
0.081 in.
1.40 mm
0.055 in.
2.60 mm
0.102 in.
615W460A
615W474A
D615-W02 May-2003