Cub Cadet 8354 Service Manual page 154

CHAPTER 4 8354/8404
c. Third Stage (Disassembly of Front wheel
drive gear assembly/MID PTO Case assembly)
1. Loosen MID PTO case (1) attaching bolt (2) and
disconnect case and gear in assembly.
2. Disconnect front wheel drive shaft assembly (3)
from transmission case.
(When reassembling)
• Wipe out oil or foreign matters from contacted sur-
face between MID PTO case (1) and transmission
case and apply with sealing agent.
Sealing agent Three bond 1208D or equivalent
d. Fourth Stage (Disassembly of Spiral Bevel
Pinion Shaft)
1. Pull out MID PTO transmission fork (3) and fork rod
(2) from bearing cover (1).
2. Pull out Hi-Lo shift fork (4) and fork rod (5).
3. Disassemble fork rod from each transmission fork.
• When disassembling locking bolt from
bearing cover, take care of Ball not to
be bounded.
CAUTION
(When reassembling)
• Make sure foreign matters is not entered Ball of
transmission fork and spring assembly hole.
• Forked portion of spring pin should be toward shaft.
Sect. Spec.
Tightening bolt M10
(A) Operating Direction
4-50
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Tightening Torque
48.0 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.5 ~ 41.2 lbf·ft
225W494A
(B) Spring Pin
(1) MID PTO Case
(2) Bolt with Washer
(3) Front Wheel Drive Shaft Assembly
(1) Bearing Cover
(2) Fork Rod (MID PTO)
(3) Transmission Fork (MID PTO)
(4) Transmission Fork (Hi-Lo Shift)
(5) Fork Rod (Hi-Lo Shift)
(6) Spring
(7) Ball
615W490A
615W492A
615W493A
D615-W02 May-2003