9.6 CLEARANCE CHECK BETWEEN
DIFFERENTIAL PINION SHAFT AND
DIFFERENTIAL PINION
1. Measure O.D. of differential pinion shaft.
2. Measure I.D. of differential pinion shaft.
3. Check clearance as the measured value and if ex-
ceeding allowable limit, renew it.
Sect.
Specified
Clearance between
0.016 ~ 0.052 mm
differential pinion
(0.00063 ~ 000205 in.)
and differential
pinion shaft
16.000 ~ 16.018 mm
Differential
pinion I.D.
(0.62992 ~ 0.63063 in.)
15.966 ~ 15.984 mm
Differential
pinion O.D.
(0.62858 ~ 0.62929 in.)
9.7 CLEARANCE CHECK BETWEEN FRONT
DIFFERENTIAL CASE, DIFFERENTIAL
CASE COVER AND DIFFERENTIAL SIDE
GEAR.
1. Measure O.D of differential side gear.
2. Measure I.D of differential side gear.
3. Measure I.D. of differential case cover.
4. Check the clearance as the measured value and if
it exceeds the allowable limit, replace it.
Sect.
Specified
Clearance between
front differential
0.016 ~ 0.052 mm
case, differential
(0.00063 ~ 000205 in.)
case cover and
differential side gear
Front differential
32.050 ~ 32.050 mm
case I.D.
(1.26083 ~ 1.26181 in.)
Differential case
32.025 ~ 32.050 mm
cover I.D.
(1.26083 ~ 1.26181 in.)
31.959 ~ 31.975 mm
Differential side
gear O.D.
(1.225823 ~ 1.25886 in.)
D615-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Allowable
limit
0.25 mm
(0.098 in.)
1.0 mm (0.039 in.) 1.2 mm (0.047 in.)
-
-
Allowable
limit
0.25 mm
(0.098 in.)
-
-
-
FRONT AXLE
615W741A
615W742A
7-21