Third Stage (Disassembly Of 25 Gear Shaft And Propulsion Shaft 1); Fourth Stage (Disassembly Of Bearing Cover Assembly) - Cub Cadet 8354 Service Manual

CHAPTER 4 8354/8404
10.3 THIRD STAGE (DISASSEMBLY OF 25
GEAR SHAFT AND PROPULSION SHAFT 1)
1. Pull out 25 gear shaft (2) from propulsion shaft
cover (1).
2. Loosen snap ring (3) for shaft and pull out 26
gear (4).
3. Pull out oil seal (5) from clutch housing and
loosen snap ring (6) for hole.
4. Pull out propulsion shaft 1 (7) with bearing.
(When reassembling)
• Renew oil seal (5), (8), and (9) and apply grease to
the contacted portion of assembly. Make sure di-
rection of assembly is correct.
10.4 FOURTH STAGE (DISASSEMBLY OF
BEARING COVER ASSEMBLY)
1. Loosen bearing cover (1) attaching bolt (2) and dis-
connect bearing cover with gears in a body.
• When difficult to disconnect bearing
cover assembly, make sure 23 gear
tooth of main shaft gear (3) engaged
with 22 gear shaft (4) tooth, and dis-
CAUTION
connect with gear tooth engaged each
other
(When reassembling)
• 26 gear should be assembled with the protruded
gear toward the bearing.
4-30
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
(1) Propulsion Shaft Cover
(2) 25 Gear Shaft
(3) Snap Ring
(4) 26 Gear
(5) Oil Seal
(1) Bearing Cover
(2) Bolt
615W449B
(6) Snap Ring
(7) Propulsion Shaft 1
(8) Oil Seal
(9) Oil Seal
615W450A
615W451B
(3) Main Shaft Gear
(4) 22 Gear Shaft
D615-W03 May-2003