Disassembly, Maintenance - Cub Cadet 8354 Service Manual

CHAPTER 3 8354/8404

2.6 DISASSEMBLY, MAINTENANCE

A. CLUTCH PEDAL CHECK AND ADJUST-
MENT
a . First Stage (Clutch Pedal Play Adjustment)
1. Press clutch pedal (1) by hand and measure play
(A) at the end of pedal.
2. If measurement exceeds the specified, loosen lock
nut (3) of clutch rod (2), re-adjust the length of clutch
rod, set pedal play and then tighten with lock nut.
Sect
Play of clutch pedal (A)
b. Second Stage (Adjustment of Clutch Pedal
Stopper Bolt)
1. When working clutch pedal when clutch is
disconnected, avoid bolt setting to prevent exces-
sive force to clutch.
2. If setting (A) of stopper bolt exceeds the specified,
loosen lock nut (2), readjust the length, and then
set with lock nut.
Sect
Stopper bolt setting
length (A)
c. Third Stage (Adjustment of Safety Switch)
1. Measure clearance (A) of safety switch (1) and clutch
pedal (2).
2. If the measured value exceeds the specified, loosen
safety switch lock nut (3).
Readjust and then lock not to be loosen.
Sect
Clearance of safety switch
and clutch pedal (A)
• Without working of clutch pedal, start
motor should not be prerated.
CAUTION
3-12
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Specified
30 ~ 40 mm
1.18 ~ 0.57 in.
Specified
27 ~ 29 mm
1.06 ~ 1.14 in.
Specified
3 ~ 4 mm
0.12 ~ 0.16 in.
(1) Clutch Pedal
(3) Lock Nut
(1) Stopper Bolt
(1) Safety Switch
(3) Lock Nut
615W321A
(2) Clutch Rod
615W322A
(2) Lock Nut
615W323A
(2) Clutch Pedal
D615-W02 May-2003