QDR InfiniBand Switch Platform User Manual
7.
Tighten the bolts that hold the rail slides onto the rack to 9.2 Nm or 81.5 pound inches.
8.
Make sure the cords come out the other side of the rack.
9.
Place both brackets on the switch so that they extend forward of the switch.
In this position the front of the switch is
~5cm behind the rack vertical support
Place to put
the power
cable.
In this position you will use 3
This configuration also allows you to put the power
cord through the bracket.
Figure 42: Power Cord Through the Rail Slide
Figure 43: Screwing on the Bracket
flat head screws
Slot in the rail slide
In this position the front of the switch
is even with the rack vertical support
In this position you will use 4
flat head screws
Mellanox Technologies
Rev 2.9
65