Figure 15: Making Room For The Power Cord; Figure 16: Screwing On The Bracket - Mellanox Technologies IS5025D-1BRC User Manual

Rev 2.9
tical support of the rack and the second option will recess the switch further into the rack. If
you are using the second option insert the power cable before screwing the bracket to the
vertical support.
In this position the front of the switch is
~5cm behind the rack vertical support
Place to put
the power
cable.
In this position you will use 3
This configuration also allows you to put the
power cord through the bracket.
4. Screw the rails onto the switch. Use 5 flat head screws to connect each rail to the switch.
30
Mellanox Technologies
If you need to bring the Power cord from the other side of the rack, recess the
switch and run the Power cord through the bracket, also using the slot in the
rail slide. See "Passing the Power Cord From the Connector Side to the Power
Side in a Full Rack" on page 57 for detailed instructions on routing the power
cord from the power side to the connector side.

Figure 15: Making Room for the Power Cord

Figure 16: Screwing on the Bracket

flat head screws
The side of the switch with these brackets will be the side that is even with or
very close to the vertical rack support.
Power cord
In this position the front of the switch
is even with the rack vertical support
Basic Operation and Installation
In this position you will use 4
flat head screws