SMART Board 600i Series Installation And Configuration Manual page 69

5. Push the replacement lamp assembly into
position in the projector head, and then firmly
press it into place to fully seat the power
connector.
6. Replace the lamp retention screw.
7. Replace the lamp cover and screw.
8. Dispose of the lamp assembly in an
environmentally friendly manner, in
accordance with local regulations.
NOTE: If the bulb failed within the warranty period, your support representative may ask
you to record the lamp hours, and return the faulty lamp assembly to SMART
Technologies. If you're asked to return the lamp assembly, please use the replacement
lamp's packaging.
To reset the lamp usage timer
After replacing the projector lamp assembly, reset the lamp usage timer. Use the Unifi software
on-screen menu or the remote control to access the projector's on-screen display.
1. Press the Settings button on the Unifi on-
screen interface, and then select Advanced
settings.
OR
Press remote control's Info button.
2. Select the Setup menu (wrench icon).
3. Select the Reset Lamp HRS option.
4. Press Yes to confirm.
99-00737-25 Rev A0 Maintaining 600i Interactive Whiteboard Systems 63