SMART Board 600i Series Installation And Configuration Manual page 28

Aligning the Unifi 35 Projector Boom
CAUTION
To adjust the Unifi 35 projector boom alignment
1. Remove the screws from the connection panel
cover using a Phillips No. 1 screwdriver, and then
remove the connection panel cover and the wire
cover from the base of the projector.
2. Completely remove the two locking screws from the projector boom mounting plate and
set them aside.
Projector Base
Plate
IMPORTANT
3. Adjust both adjustment screws at the same time, and don't turn the screws more than a
quarter turn (90°) at a time.
– If the image is wider at the bottom, turn the adjustment screws counter-clockwise to
lower the boom.
– If the image is wider at the top, turn the adjustment screws clockwise to raise the
boom.
NOTE: You may have to adjust the projector boom length and focus slightly during this
step.
22
Read the following procedure carefully before adjusting the boom alignment.
Improper adjustment can damage the projector severely, potentially voiding the
projector's warranty.
Projector Boom
Mounting Plate
You can damage the projector boom mounting plate or the projector base
plate if you do not remove the locking screws before adjusting the boom
alignment.
Installing 600i Series Interactive Whiteboard Systems
Alignment Adjustment
Screws
Locking Screws
(shown removed)
Screw Screw
Wire Cover
Connection
Panel Cover
Projector Boom
99-00737-25 Rev A0