SMART Board 600i Series Installation And Configuration Manual page 34

8. Insert the anchors (included) into all of the drilled
holes, and then screw them in until they are flush
with the drywall surface. See page 10 for an
illustration of the anchor. Do not use a hammer to
insert the anchors.
9. Screw the anchor bolts with washers into the
bracket anchors, leaving the heads about 1/4"
(6 mm) from the wall surface. Don't screw in the
bolt for the security cable at this time.
10. Hang the projector bracket on the five screws and
anchor bolts, use a carpenter's level to ensure that
the bracket is level, and then tighten the screws
and bolts securely.
11. Go to To mount the projector on the bracket on page 12 to complete the upgrade.
To position the projector above the interactive whiteboard — concrete wall
1. Using a pencil and a carpenter's level, draw a
vertical line on the wall about 2" (5 cm) to the right
of the center of the interactive whiteboard's wall
bracket.
2. Position the installation template on the wall with
the three holes indicated in the diagram centered
on the vertical line.
3. Slide the template up or down the wall until the row
of marks for your interactive whiteboard model
aligns with the row of screws in the mounting
bracket. Use a carpenter's level to ensure that the
template is level. Tape the template to the wall.
NOTES
– The markings on the template may not align
with the mounting bracket screws.
– Be sure to position the projector bracket at
least 5" (12.7 cm) from the ceiling, in order to
provide adequate airflow around the projector.
28 Installing 600i Series Interactive Whiteboard Systems
Wall Mount
Bracket
Centerline
Align With
of Bracket
Bracket
Holes
Holes
99-00737-25 Rev A0
Center of
Wall Bracket
Center
Holes on
Line