SMART Board 600i Series Installation And Configuration Manual page 53

The Unifi Projector External Indicators and Controls
The Unifi 35 projector has the following indicators and
controls on its base:
• a Power button
• a status LED
• a keypad to control the on-screen display
The remote control's infrared sensor is located behind
the transparent red window below the Power button.
The Unifi Projector Power Button
You can use the external Power button on the projector base as another way of turning the
600i system on or off. Normally, you would use the control module or remote control's Power
button to turn the unit on and off.
NOTE: If you press this Power button to turn off the system, the projector lamp turns off
immediately, and your ScratchPad pages are cleared without warning.
The Unifi Projector Status Indicator
The status indicator LED beside the Power button provides more detailed information about
the projector's state. This table shows possible indications and their meaning.
When the status LED is...
flashing green
solid green
flashing red
flashing amber
solid amber
solid red
fast flashing amber
The Unifi Projector Keypad
You can use the keypad on the projector base as another way to adjust the projector's display
and audio settings. Normally, you would use the projector's on-screen interface or the remote
control to adjust these settings.
The Extended Connection Panel Power Button
You can use the Power button on the extended
connection panel (ECP) as yet another way to turn the
600i system on or off. Normally, you would use the control
module or remote control's Power button to turn the
system on and off.
NOTE: If you press this Power button to turn the system
off, the projector lamp turns off immediately, and your
ScratchPad pages are cleared without warning.
99-00737-25 Rev A0
it indicates that...
the projector lamp is starting up
the projector is in the normal On state
the projector is in a two-minute cool down period, and
lamp restart is locked out
the projector is in a three-minute cool down period, and
the lamp can be restarted
the projector is in Standby mode
the projector is in an error state
the projector's firmware is being updated
Using a 600i Series Interactive Whiteboard System
Power Button
Status LED
Remote
Control
Sensor
Keypad
Window
ECP
Power
Button
47