SMART Board 600i Series Installation And Configuration Manual page 35

4. Mark the six holes for the projector mounting plate
anchors and the security cable anchor, and then
remove the template from the wall.
5. At each of the marks (including the security cable
mark) drill 5/16" (8 mm) holes into the concrete
wall.
6. Insert the included concrete anchors into all of the
drilled holes, pushing them in until the sleeve is
flush with the wall surface. Tighten the nuts to
secure the anchor in the wall, and then remove the
nuts. See page 11 for an illustration of the anchor.
7. Place a washer on each bolt, and then replace the
nuts, leaving them about 1/4" (6 mm) from the wall
surface. Don't screw in the bolt for the security
cable at this time.
8. Hang the projector bracket on the five screws and
anchor bolts, use a carpenter's level to ensure that
the bracket is level, and then tighten the nuts
securely.
9. Go to To mount the projector on the bracket on
page 12 to complete the upgrade.
99-00737-25 Rev A0 Installing 600i Series Interactive Whiteboard Systems 29