SMART Board 600i Series Installation And Configuration Manual page 66

To remove the pen tray
NOTE: Electrostatic discharge protection is not required for this operation.
1. Turn off the interactive whiteboard by disconnecting the USB cable connected to the Unifi
projector or turn off the 600i interactive whiteboard system and wait until the indicator ring
on the control module is solid white and the fans have stopped running.
2. Remove the pens and the eraser from the pen tray.
3. Reach underneath the pen tray, and disconnect the modular I²C cables from connectors 1,
2 and 3. See page 16 for connector locations.
4. If you have secured the pen tray to its brackets using two screws (page 24), remove these
screws.
5. If you have secured the pen tray using a Kensington lock or similar device, unlock and
remove the lock.
6. Reach underneath the pen tray and pull down on the two large plastic clips on the bottom
of the pen tray. The ends of these clips project downwards slightly, so they're easy to find.
7. While continuing to apply downward pressure to the clips, gently slide the pen tray toward
you until it's free of the two L-shaped metal brackets.
NOTE: To reinstall the pen tray, simply reverse these steps.
60
The Pen Tray as Seen from Below
Plastic Clips
Maintaining 600i Interactive Whiteboard Systems 99-00737-25 Rev A0