SMART Board 600i Series Installation And Configuration Manual page 47

To orient the interactive whiteboard
To orient the unit, follow on-screen instructions for
touching specific points on the interactive
whiteboard's screen.
• You can use the Unifi projector's interface to
perform a 9-point orientation.
• If you are using a computer with SMART
Board software, you can perform a 4-, 9-, 12-
or 20-point orientation, depending on your
Alignment/Orientation Precision setting. The
next procedure shows how to change the
precision setting.
The picture to the right shows SMART Board software's 9-point orientation screen. The Unifi
software orientation screen is similar.
To access the orientation screen, press and hold the two large pen tray buttons at the same
time. If your 600i is connected to a computer with SMART Board software, the SMART Board
software orientation screen opens. Otherwise, the Unifi interface's orientation screen opens. If
you are using a computer, you can also press the Help button on the pen tray and select
Align/Orient the SMART Board.
NOTE: Use a fine-point tool, such as a pen tray pen, instead of your finger for greater precision
when touching the targets.
To set the orientation precision
NOTE: You can perform this procedure only if a computer with SMART Board software is
connected to the 600i system.
1. Press the SMART Board icon.
2. Press Control Panel.
3. Press the SMART Board Settings button.
4. If more than one SMART product is connected to the computer, select the appropriate
interactive whiteboard.
5. Select Orientation/Alignment Settings from the list.
6. Select the desired orientation setting, and press OK.
NOTES
• The changes to the orientation precision takes effect the next time you orient the system.
• Changing the orientation precision has no effect when you perform an orientation
procedure using the Unifi projector's interface.
99-00737-25 Rev A0 Connecting the 600i System to a Computer 41