SMART Board 600i Series Installation And Configuration Manual page 37

6. Select the Yes option, and then click Next to begin the SC9 firmware update.
The Ready light flashes amber during the update.
7. When the update is complete, click Next, and then click Finish.
The interactive whiteboard restarts automatically, and the Ready light is solid green.
8. Reconnect the USB cable between the interactive whiteboard's SC9 controller and the
Unifi projector.
NOTE: If the firmware update is unsuccessful, repeat the procedure. If the update is
unsuccessful after a second attempt, contact your support representative.
99-00737-25 Rev A0 Installing 600i Series Interactive Whiteboard Systems 31