SMART Board 600i Series Installation And Configuration Manual page 17

2. Position the installation template on the wall with
the three indicated holes centered on the line.
3. Slide the template up or down the wall until it is at
the desired height as recommended by the line at
the bottom of the template using a measuring tape
or ruler. Use a carpenter's level to ensure that the
template is level.
NOTE: Position the projector bracket at least 5"
(12.7 cm) from the ceiling in order to ensure
adequate airflow around the projector.
4. Locate the row of marks on the template that
identify the location of the bracket mounting holes
for your model of interactive whiteboard. Use a
pencil to mark the wall at each anchor location.
5. Mark the six holes for the projector mounting plate
anchors and the security cable anchor, and then
remove the template from the wall.
6. At each of the marks (including the security cable
mark) drill 5/16" (8 mm) holes into the concrete
wall.
7. Insert the included concrete anchors into all of the
drilled holes, pushing them in until the sleeve is
flush with the wall surface. Tighten the nuts to
secure the anchor in the wall, and then remove the
nuts.
99-00737-25 Rev A0 Installing 600i Series Interactive Whiteboard Systems
Center
Holes on
Line
Concrete
Anchor Bolt
11