SMART Board 600i Series Installation And Configuration Manual page 33

To position the projector above the interactive whiteboard — framed wall
1. Using a stud finder, locate the stud closest to the
center of the 600 series interactive whiteboard wall
bracket.
2. Using a pencil and a carpenter's level, draw a
vertical line on the wall, marking the stud's
centerline.
3. Position the installation template on the wall with
the three holes indicated in the diagram centered
on the stud.
4. Slide the template up or down the wall until the row
of marks for your size of interactive whiteboard
aligns with the row of screws in the mounting
bracket. Use a carpenter's level to ensure that the
template is level. Tape the template to the wall.
NOTES
– The markings on the template probably won't
line up with the mounting bracket screws.
– Be sure to position the projector bracket at
least 5" (12.7 cm) from the ceiling in order to
provide adequate airflow around the projector.
WARNING
5. Mark the six holes for the projector mounting plate
anchors and the security cable anchor, and then
remove the template from the wall.
6. For a wooden stud wall, drill a 1/8" (3 mm) pilot
hole at the three center marks, and then screw in
one of the included pan-head wood screws with a
washer into each of the top two holes, leaving the
heads about 1/4" (6 mm) from the wall surface.
Don't screw in the security cable screw at this time.
For a metal stud wall, drill 7/16" (11 mm) holes
through the drywall and the stud at each of the two
center marks and the security cable mark.
7. Drill 5/16" (8 mm) holes at the remaining three
marks.
99-00737-25 Rev A0
When mounting the projector on a framed wall, you must attach the
mounting bracket to a stud that can support the projector's weight. If you
use drywall anchors only, the anchors or the drywall may not be able to
support the projector, resulting in product damage and possible personal
injury.
Installing 600i Series Interactive Whiteboard Systems
Mounting
Bracket
Align With
Bracket
Holes
Center
Holes on
Stud
27