Acculab ATL-224 Operating Instructions Manual page 7

NOTE: This equipment has been tested and found to
comply with the limits pursuant to part 15 of FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with these instructions,
may cause harmful interference to radio communications.
For information on the specific limits and class of this
equipment, please refer to the Declaration of Conformity.
Depending on the particular class, you are either required
or requested to correct the interference.
If you have a Class A digital device, you need to comply
with the FCC statement as follows: "Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense."
If you have a Class B digital device, please read and follow
the FCC information given below:
"However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help."
Before you operate this equipment, check which FCC class
(Class A or Class B) it has according to the Declaration of
Conformity included. Be sure to observe the information of
this Declaration.
7