Change Password - DFI 486-OCV Plus User Manual

Pentium OverDrive Ready System Board
TM

Change Password

The default password is AMI. If you want to change
the password, make sure you set the Password Checking
Option to "Always" or "Setup" under Advanced CMOS
Setup. If not, the error message below will appear on
the screen:
<Password Option> must be enabled in Advanced CMOS Setup
Use the arrow keys to highlight the Change Password
Option and press <Enter>. The message below will
appear.
The preset password is AMI. Type AMI or the current
password and press <Enter>. The message below will
appear:
Type in the the new password. You are limited to six
ASCII characters. If you type more than six characters,
you will get the following error message:
3-8 u Initial Setup Program
Press any key to continue
Enter Current Password:
Enter NEW Password:
Error, press any key