Table of Contents
Advertisement
Memory Errors
007-5653-001
When a No_Memory_Beep_Code is issued by the system, check the following:
1.
Make sure that the DIMM modules are properly and fully installed.
2. Check if different speeds of DIMMs have been installed. Use the same RAM speed for all
DIMMs in the system.
3. Make sure you are using the correct type of DDR3 Registered ECC or Unbuffered ECC/Non
ECC 1333 MHz/1066 MHz/800 MHz SDRAM (recommended by the manufacturer.)
4. Check for bad DIMM modules or slots by swapping a single module between all memory
slots and check the results.
5. Make sure that all memory modules are fully seated in their slots.
6. Check the position of the 115V/230V switch on the power supply.
7. Follow the specifications given in
memory modules.
Note: The ISS3500 has 12 240-pin DIMM slots that support up to 96 GB of DDR3 Registered
ECC or up to 24 GB of Unbuffered ECC/Non ECC 1333 MHz/1066 MHz/800 MHz SDRAM
modules. Do not mix memory modules of different speeds and sizes.
"DIMM Slot Population" on page 31
Memory Errors
to install your
81
Advertisement
Table of Contents
