Table of Contents
Advertisement
Follow the steps below to program the TV code when you already know the three-digit code. (For a list of codes,
see
"TV and VCR Codes" on page
Press the LED key and hold it down until the LED flashes rapidly.
1.
Press the REC key. The LED stops blinking at this point and stays on solid.
2.
Press and release the C key. The remote is now in programming mode.
3.
Enter the three-digit code that corresponds to the brand name of the TV.
4.
page 39.
If the code is valid, the LED will flash on and off three times and then remain off.
If an invalid code is entered or a 20 second lapse in button presses occurs, the LED will turn off and the
remote control will return to normal operation. You will need to repeat the above procedure to program the
TV code.
P
ROGRAMMING THE
To program a TV code by using the search or scan method:
Press the LED key and hold it down until the LED flashes rapidly.
1.
Press the REC key. The LED stops blinking at this point and stays on solid.
2.
Press and release the POWER key. The remote is now in TV code scan programming mode.
3.
Press the up key to scan through all TV codes. When you reach the correct TV code, the TV will automati-
4.
cally turn on, or off if it was previously on. Note that the LED will flash rapidly once you have scanned
through all the codes, and then it will continue to go through the codes again in a continuous wrap.
Press the SELECT button to store the TV code. The LED flashes rapidly, then stops, indicating that the TV
5.
code has been stored.
If you press the up key too rapidly, you may pass the TV code before the time the TV turns on or off. If you
6.
are not sure you are storing the correct TV code, press the down key slowly to cycle back through codes that
have been previously scanned.
When the TV turns off, or on if it was previously off, press SELECT at that point to store the TV code.
7.
V
TV C
ERIFYING THE
To playback the TV code:
Press the LED key and hold it down until the LED flashes rapidly.
1.
Press the INFO key. The LED stops blinking at this point and stays on solid.
2.
Press and release the C key. The remote is now in playback mode.
3.
Observe the LED. The TV code will be indicated by a blink sequence for each number. See example below.
4.
For example, code 130 would show as the following:
<pause> <long blink> <off> (represents 1)
<pause> <long blink> <long blink> <long blink><off> (represents 3)
<pause> <short burst of flickering blinks> <off> (represents 0)
39.)
TV C
U
C
ODE
SING
ODES
S
M
ODE
EARCH
ETHOD
See "TV Codes - SRC 300" on
21
Advertisement
Table of Contents
