Read-Out Mode ( ); Fan Speed Mode ( ); Failure Mode ( ) - REMEHA Gas 110 Eco 115 Installation, User And Service Manual

4.7 Read-out mode (
To check boiler set points and values.
Using the - key, press repeatedly until
" "
in the "code"-display. Then select the required code
etc. using the -key.
" "
Code Description
Actual flow temperature
Actual return temperature
Actual DHW temperature (only with sensor connected)
Actual outdoor temperature (only with sensor connected)
N/a
Flow temperature (set point)
Actual heat demand status
Calculated HTG cut-in temperature
Actual flow temperature rise [0.1 °C/sec]
N/a
4.8 Fan speed mode (
Using the - key, press repeatedly until "code"-display shows
" "
alternate flashing half digits.
Code Description
Fan speed
Fan speed
4.9 Failure mode (
To check the latest failure with the accompanying operating codes
and relevant temperatures.
Using the - key, press repeatedly until
" "
in the "code"-display.
Code
Example as above:
Failure code indicates the return temperature sensor failed
during HTG operation (
return temperature of 40 °C and DHW temperature of 60 °C.
25/01/2011 - 300014883-001-K
)
(flashing dot) appears
,
)
Example 7000 r/m
hundreds
units
)
(flashing digit) appears
Description
Display of failure code
§ 8.2
Operating mode during failure
Flow temperature during failure
Return temperature during failure
DHW temperature during failure
N/a
), at a flow temperature of 53 °C, a
or
The value in the
alternate double digits as table:
Then select the required code
key and read off the relevant value.
Gas 110 Eco 115 / 65
Read-out (example)
= demand
= no demand
-display shows the actual fan speed using two
, or etc. using the -
" "
25