Table of Contents
Advertisement
4 Control and safety equipment
4.1 Control panel
4.1.1
General
The boiler is supplied with a standard set of defaults pre-programmed
for normal operation but can be tailored by the Engineer to suit most
site conditions. These values are set and read using the built in
control panel or with a notebook computer (with an interface and
software available on request).
4.1.2
Layout of the control panel
"code"-display
Indicates on user level:
Additional indication on service level:
-display
Indicates:
reset-key:
Key " ":
Key "
":
Key
+ Symbol
Key "
":
Key "
" + Symbol
Key [+]:
Key [+] + Symbol
Key [-]:
Key [-] + Symbol
14
Operating mode: only one digit
Setting mode: digit with dot
Read-out mode: digit with flashing dot
Shut-off mode: letter
Forced full load: letter
Forced part load: letter
Fan speed mode: alternate half digit
Failure mode: flashing digit
Temperatures, settings, fault codes (flashing digits), shut-off codes (flashing dots)
To reset after a lockout condition
Program function: key to select the required mode
Program function: key to select the required program within the selected mode
:
Switch function: burner switch HTG (manual override)
Program function: key to save the settings
Switch function: burner switch DHW (manual override)
Program function: to select a higher setting
Switch function: pump manual override
Program function: to select a lower setting
:
Switch function: manual override (hand/auto)
For security the control has three levels of access:
- User level - free access
- Service level - access with service code by qualified personnel
- Factory level - access by PC with factory code (Remeha only).
Gas 110 Eco 115 / 65
25/01/2011 - 300014883-001-K
Advertisement
Table of Contents
