Assembling The Outer Rails - HP AA-RSB6B-TE Installation Manual

Installing the SAN Switch 2/8
Outer rail alignment pins
1
Figure 11: Assembling the outer rails
5. Assemble each of the two inner rails (one on each side of the switch and
42
1
2
plenum) using eight #8-32 x 5/16 Phillips pan-head screws (with attached star
lock washers) and eight #8 flat washers as shown in
Caution: Do not use any other screws other than the eight that are provided.
Use of any longer lengths can cause damage to internal components of the
switch. Be sure to install the flat washers along with the pan-head screws.
Before tightening screws, make sure that the rails are centered to the overall
height of the switch.
SHR-2560A
M5 torx screws
2
hp StorageWorks SAN Switch 2/8 Installation Guide
Figure 12.