Configuring The Ip And Fibre Channel Address - HP AA-RSB6B-TE Installation Manual

Managing the SAN Switch 2/8
3. At the New Username prompt, enter a new name for the admin user. You
4. At the Old Password prompt, enter the old password.
5. At the New Password prompt, enter the new password. The new password
6. At the New Password prompt, enter the new password exactly as entered to
7. Press Enter to commit the configuration to the firmware.

Configuring the IP and Fibre Channel Address

The SAN Switch 2/8 is shipped with a default IP address of 10.77.77.77. Use
these steps to change the default IP Address and configure the Fibre Channel IP
address of the switch.
1. Log in to the switch as the admin user.
2. At the command line enter the following command:
3. At the Ethernet IP Address prompt, enter the new IP address for the Ethernet
4. At the subnetmask prompt, enter the address of the subnetmask, if applicable.
5. At the Fibre Channel IP address prompt, enter the Fibre Channel IP address
6. At the Fibre Channel subnetmask prompt, enter the address of the
7. At the gateway address prompt, enter the IP address of the gateway system if
8. Enter y at the prompt to have the IP address changes take effect immediately.
68
An interactive session is opened and you are prompted for configuration
values.
can change the name of the admin user without changing the password. Press
Enter to leave the name as is.
must be from 8 to 40 characters in length.
the previous prompt.
ipAddrSet
An interactive session is opened and you are prompted for configuration
values. Press Enter to skip over a prompt and leave the parameter value as is.
port on the switch. Press Enter to continue.
Press Enter to continue.
for the switch. Press Enter to continue.
subnetmask, if applicable. Press Enter to continue.
applicable. Press Enter to continue.
The configuration is committed to the switch firmware.
hp StorageWorks SAN Switch 2/8 Installation Guide