Verifying Operation; Inserting A Cable Into An Sfp - HP AA-RSB6B-TE Installation Manual

Installing the SAN Switch 2/8
4. Connect the cables to the SFPs as appropriate to the fabric topology, by
Figure 17: Inserting a cable into an SFP
Note:
cable does not slide in easily, check the orientation.

Verifying Operation

After making the appropriate connections, as outlined in this chapter, use these
steps to verify that the switch is running properly.
1. Access your browser.
2. At the URL address window type, http://your switch IP
3. Press Enter.
4. If connected properly, the name of your switch appears (in green) in the Web
56
positioning each cable so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the SFP. See
The cable is keyed so that it can only be inserted correctly into the SFP. If the
address.
browser window, indicating Healthy/OK.
Figure
SHR-2499B
hp StorageWorks SAN Switch 2/8 Installation Guide
17.