Installation And Safety Guidelines; Selecting An Operating Location; Cooling Requirements - HP AA-RSB6B-TE Installation Manual

Installing the SAN Switch 2/8

Installation and Safety Guidelines

Read the following sections for installation guidelines. Install the SAN Switch
2/8 in one of the following ways:

Selecting an Operating Location

To ensure correct operation of the switch, the location where the switch is in use
must meet the following requirements:

Cooling Requirements

Cooling air is drawn into the switch chassis by the fans mounted on the rear of the
chassis. The air is expelled through vents in the front of the chassis. HP
recommends installing the switch so that air intake and exhaust for all components
in the rack is flowing in the same direction.
30
as a stand-alone unit on a flat surface, or
as a fixed component in the HP 9000 Series (or comparable) EIA Rack using
the Fixed Rack Mount Kit provided. Fixed Rack Mount Kit contents are
outlined in Table 3.
as a fixed component in the HP System/e rack models
Adequate supply circuit, line fusing, and wire size, as specified by the
electrical rating on the switch nameplate.
An air flow of at least 300 cubic feet per minute, available in the immediate
vicinity of the switch.
If installing the switch in the HP 9000 Series, HP System/e, or comparable
Electronics Industries Association (EIA) rack:
— All equipment installed in the rack should have a reliable branch circuit
ground connection, and should not rely on a connection to a branch
circuit, such as a power strip.
— The rack should be balanced and the installed equipment within the rack's
weight limits. Ensure the rack is mechanically secured to ensure stability
in the event of an earthquake.
Caution:
Do not block air vents. Blocking switch air vents may result in the switch
overheating.
hp StorageWorks SAN Switch 2/8 Installation Guide