Specifying Custom Status Policies - HP AA-RSB6B-TE Installation Manual

Installing the SAN Switch 2/8
3. Enter y after the Fabric Parameters prompt.
4. Enter a unique domain ID (such as the domain ID used by the previous
5. Complete the remaining prompts (or press CTRL+D to accept the remaining
6. Re-enable the switch, type:

Specifying Custom Status Policies

Optional. If desired, specify any custom status policies for the fabric as follows.
1. Enter the following at the prompt.
2. Specify the desired status policies. To completely deactivate the alarm for a
54
Fabric parameters (y, n)
switch, if still available).
Domain: (1..239) [1] 3
settings without completing all the prompts).
switchEnable
switchStatusPolicySet
particular condition, enter 0 at the prompt for that condition.
hp StorageWorks SAN Switch 2/8 Installation Guide