Control Buttons; Power Indicator Leds - Extron electronics SMX System User Manual

Control Buttons

d
Control selection buttons — These four buttons give direct
access to the enter (save), preset, view, and Esc (exit) controls.
Each button has a separate function.
NOTES:
Enter button — The Enter button flashes green when a change to an input or output
tie is pending, or red when a preset recall is pending. Pressing the flashing button saves
the change or recalls the preset, and the Enter button and any lit input and output
buttons extinguish (see
Preset button — The Preset button gives access to recall or save up to 32 global presets
(using I/O buttons 1 through 16), and 10 plane presets (using input buttons 1 through
10). The button lights red when pressed. Upon recalling or saving the preset, the button
and all input and output buttons (lit red) are extinguished (see
on page 16 and
NOTE:
View (
quick viewing of existing input and output ties. When the button is lit, after selecting
a plane and an associated input, muted outputs flash and untied outputs light the
appropriate signal color (red, green, or amber). Tied outputs remain unlit.
NOTE:
>
Esc (
plane, input, and output buttons are extinguished.
NOTE:
Also, when used in combination, the buttons have the following functions:
Control Button Combination
Enter

Power Indicator LEDs

e
Power indicator LEDs — These two LEDs, labeled Main and I/O cards, light green
when power is applied to the unit. The LEDs light red when the main or redundant
power supply fails.
Configuring the Rear Panel RS-232/RS-422 Port
• See
serial port configuration details.
• See Setting the Front Panel Locks (Executive Modes)
executive modes details.
Front Panel Operation
Saving and Recalling I/O Presets
Global presets save and recall the configuration for all planes. Plane presets
save and recall the configurations for a specific plane without affecting the
other plane connections.
) button — This button, when pressed and released, lights red and allows
<
Use this button to decrease settings for RGB delay, input audio level, and
output audio volume. This button also mutes and unmutes outputs (see the
Muting or Unmuting a Video, Audio, or Video and Audio Output
page 20).
) button — This button, when pressed, flashes green once and all lit control,
Use this button to increase the RGB delay, input audio level, and output
audio volume.
Preset View Esc
Preset View Esc
View Esc
on page 16).
Front Panel Operation
on page 22).
Function
Selects the serial port configuration.
Toggles between executive modes 2x and 0x.
Toggles between executive modes 2x and 1x
or initiates a system reset.
SMX System MultiMatrix Switcher • Operation
ENTER PRESET VIEW ESC
on page 26 for
on page 25 for
on
15