Control.buttons - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd
Control buttons
Primary functions
Action:
Indication:
Secondary functions
I/O Grouping Action/
indication:
Port Action 1:
configuration
Action 2/
indication:
Front panel Action:
locks
RGB delay Action:
Audio Action:
c
3-6 CrossPoint / MAV Matrix Switchers • Operation
Save changes Select Preset mode
Blink: save needed Blink: Save preset
Lit: Recall preset
ENTER PRESET
Select group 1. Select group 2.
Select 9600 baud. Select 19200 baud.
Blink: selected Blink: selected
With Video and
Audio, select Lock
mode 2 or toggle
between mode 0 and
mode 2.
Enter button — The Enter button has two primary functions (•) and four
secondary functions (❏):
• Save configuration or preset changes that you make on the front panel.
To create a simple configuration:
Specify RGBHV (CrossPoint switchers) or video (MAV Plus

switchers), audio, or both (see I/O selection buttons [
Press the desired input button (

Press the desired output button(s) (

Press the Enter button.

• Indicate that a potential tie has been created but not saved.
In the I/O Group mode, select group 1 and indicate the selection. See
❏
"I/O grouping" on page 3-24.
With the Preset, View, and Esc buttons, select Serial Port Selection and
❏
Configuration mode. See "Selecting the rear panel RS-232/RS-422 port
protocol and baud rate" on page 3-54.
Select 9600 baud for the rear panel RS-232/RS-422 port in Serial Port
❏
Selection and Configuration mode and indicate the selection. See "Selecting
the rear panel RS-232/RS-422 port protocol and baud rate" on page 3-54.
With the RGBHV/Video and Audio buttons, select front panel security
❏
Lock mode 2 or toggle between mode 0 (unlocked) and mode 2. See
"Setting the front panel locks (Executive modes)" on page 3-52.
Select View mode
View mode selected
VIEW
Select group 3.
Select Configuration mode
Select 38400 baud.
Blink: selected
CrossPoint:
In RGB Delay
mode, decrease the
switching interval.
In Audio mode,
decrease input level
or output volume.
).
a
b ).
Cancel/escape
Flashes once
ESC
Select group 4.
Select 115200 baud.
Blink: selected
In RGB Delay
mode, increase the
switching interval.
In Audio mode,
increase input level
or output volume.
] and [ ]).
g h