Xantrex XM 1000 Owner's Manual page 35

Xantrex_PRO1800.book Page 16 Tuesday, April 24, 2007 11:33 AM
Installation
AC output
ground screw
AC knockout
Figure 3-5 XM 1800 AC Wiring Compartment
8. Strip about 2 inches (50 mm) from the jacket of the AC input cable.
9. Strip approximately 3/8 inch (10 mm) off the insulation of each
10. Run the AC cable through the right-hand side strain-relief clamp and
11. Fasten the Ground wire to the grounding screw.
12. Using the 1/8 inch slot screwdriver, loosen the wire attachment
CAUTION: Reverse polarity
Improper connections (connecting a line conductor to a neutral conductor, for
example) will cause the XM 1800 to malfunction and may permanently damage
the inverter. Damage caused by a reverse polarity connection is not covered by
your warranty.
13. Insert the Line and Neutral wires into the corresponding terminals.
14. Tighten the wire attachment screws to a torque of 1.3–1.8 lbf-ft
3–16
A separate screw is provided to connect the AC input ground (see
Figure 3-5 on page 3–16).
STATUS
Utility
Input Voltage (V)
Select
Battery
Input Current (A)
Fault
Output Power (W)
GND
AC
N L N
OUT
CAUTION!
Do not connect the AC OUT to any other
source of power. Damage to unit may occur.
The AC input cable may be either solid or stranded, but must have
three conductors and be sized as in Table 3-3 on page 3–14. (The AC
terminal block accepts wire sizes up to No. 10 AWG.)
conductor.
into the wiring compartment.
screws on the terminals.
(1.76–2.44 Nm). Leave some wiring slack inside the wiring
compartment.
AC input
ground screw
XM1000
AC knockout
GND
AC
L
IN
975-0263-01-01