Connection To Network; Connecting Devices; Connecting Video Sources - Mavix MediaRacer 100 User Manual

C
ONNECTION TO
Connect one end of a communication cable (CAT5 direct cable) to the 10/100 connector
on the front panel of the MediaRacer® 100 unit. Connect the other end of the
communication cable to your local Ethernet network (SWITCH/HUB). Verify that the
LNK LED is lit.
C D
ONNECTING EVICES

CONNECTING VIDEO SOURCES

1. One video source may be attached to the MediaRacer® 100.
In order to attach a video source, connect one end of a video
coax 75 Ω cable to the video output of the Camera. Connect
the other end of the cable to one of the VIDEO IN
connector, located on the unit front panel. The lit LED
indicates the camera that has been selected from the attached
cameras.
Note: Pay attention to maximum coax cable length as
defined in the Specifications section.
MediaRacer® 100 [Preliminar y]
---MAVIX---
N
ETWORK
Comment
????? ??? ?
???? " ? " ???? " ??? ??
socket connector
???
"?? ? ???? ?????? ?? ??? ' ?
???? ?????? " ? ? ??' ? ? ?? ?
connector
??? ??? ??? ??? ?
connector
? ? ? ? " ?
socket
"
25
????? ?? ??
" ? ?