Power Connection - Mavix MediaRacer 100 User Manual

---MAVIX---
P C
OWER ONNECTION
Connect one end of the desktop power supply (supplied with the unit) to the MediaRacer®
100 unit, using the POWER connector. Connect the other cable to an AC power source.
Verify that the ON LED (located on the front panel) is lit and that after several seconds the
FLT LED goes out.
IMPORTANT:
Always connect the desktop power supply to the unit before you connect it to the mains
power supply. Failure to do this can cause irreversible damage to the Media Racer 100.
Special care must be taken to connect the cables in the proper sequence. First, connect the
desktop power supply DC cable to the MediaRacer® 100 unit, using the POWER DC
connector, then connect the other power supply cable to an AC power source.
24
MediaRacer® 100 [Preliminar y]