Model Removal - 3D Printing Systems Up Plus User Manual

including the raft and any support material. including the raft and any support material.
The price as 6/10/12 for ABS plastic from /12 for ABS plastic from
working out to be 0.06 cents per gram. cents per gram.

5. Model Removal

When the model has finished s finished printing, the printer will beep, and the nozzle and platform stop
heating. Open the door, remove the clips and s Open the door, remove the clips and slide the Perfboard out from the printer platform
Slide the spatula under the model and slowly wiggle it bac the spatula under the model and slowly wiggle it back and forth to pry loose the model.
TIP: Remember to use gloves se gloves as the platform and model may still be hot. The spatula is sharp,
gloves must be worn.
CAUTION: It is strongly recommended that you wear safety glasses and CAUTION: It is strongly recommended that you
remove the model from the ve the model from the Perfboard or the support material from the model
UP Plus 3D Printer User Manual 3D Printer User Manual
www.3DPrintingSystems.com
moval
or the support material from the model.
was AU$59 per 1KG was AU$59 per 1KG
nozzle and platform stop
printer platform.
k and forth to pry loose the model.
The spatula is sharp,
safety glasses and gloves to
v 2013.1.31 .1.31