Table of Contents
Advertisement
Support Options (Smart Support)
(Smart Support)
The software's Smart Support is where the
The software's Smart Support is where the
software will automatically calculate where it
software will automatically calculate where it
requires support material. The Bunny on the
requires support material. The Bunny on the
left was printed with 80 degree support and
left was printed with 80 degree support and
then the support material is broken away to
then the support material is bro
reveal the end result on the right
on the right. The recom-
mended setting is 30 or 10 degrees.
Support Angle: (Recommended Angle:30)
Support
Angle at
support material only gets used if angle of surf
support material only gets used if angle of surface is greater
horizontal
horizontal (so support material is almost not used unless there is a direct ove
hang), If set to 50° than support material is used for any surface
than support material is used for any surface that is greater than 5
horizontal. In the image on the left of a gre
In the image on the left of a green curve, the red indicates the amount of support
material, changing the angle higher will produce more support.
material, changing the angle higher will produce more support.
Set to > 10°
UP Plus 3D Printer User Manual
3D Printer User Manual
Semi-Hollow Honeycomb
Hollow Honeycomb: The Part is made
low, which gives you the weakest part
time. Parts with flat top surfaces can
Parts with flat top surfaces can slightly droop
with this setting.
degrees.
at which support material gets inserted. For example if 10
(so support material is almost not used unless there is a direct over-
en curve, the red indicates the amount of support
Set to > 50°
The Part is made mostly hol-
part but faster print
. For example if 10° is used,
greater than 10° from
is greater than 50° away from
v 2013.1.31
.1.31
Advertisement
Table of Contents
