Table of Contents
Advertisement
1.2.2 The following
following classifications are used in this manual
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
lt in minor or moderate injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, may
WARNING: Indicates a potentially hazardous situation which, if not avoided, may
WARNING: Indicates a potentially hazardous situation which, if not avoided, may
result in serious injury.
result in serious injury.
Gloves: When performing certain maintenance procedures, the machine may be hot
Gloves: When performing certain maintenance procedures, the machine may be hot
Gloves: When performing certain maintenance procedures, the machine may be hot
and gloves are required to avoid burns.
and gloves are required to avoid
Safety Glasses: Wear safety glasses to avoid injury to your eyes.
Safety Glasses: Wear safety glasses to avoid injury to your eyes.
1.2.3 Protection
The printer must not be exposed to
exposed to water or rain, or damage may occur.
Do not shut down the UP System
model data may be lost.
When using the "Extrude" function, keep
"Extrude" function, keep at least 50mm between the nozzle and the platform. If
too close, the nozzle may get blocked.
The printer is designed to work properly
humidity of between 20% and 50%
between 20% and 50%; Operating outside these limits may result in low quality
els.
1.2.4 3D Printer burn in test
1.2.4 3D Printer burn in test
Before shipping your printer has undergone
our printer has undergone a thorough test. You will notice in the maintenance
screen that it reports several KG's of usage, this is normal and from testing prior to leaving the
screen that it reports several K
factory.
1.2.5 Status Indicators
1.2.5 Status Indicators
LED State
UP Plus 3D Printer User Manual
3D Printer User Manual
System or pull out the USB cable when loading a digital
blocked.
work properly at an ambient temperature of between 15
, this is normal and from testing prior to leaving the
Solid Red
Solid Green
2. Overview
2. Overview
manual.
digital model, or the
between the nozzle and the platform. If
between 15°C and 30°C and
result in low quality mod-
ou will notice in the maintenance
Indicates
Printer is not intilised
intilised
Printer is ready
Printer is ready
v 2013.1.31
.1.31
Advertisement
Table of Contents
