Model Removal - 3D Printing Systems UP Plus 3D Manual

The main factor that will affect model cost is the honeycomb fill structure and support material. If, The main factor that will affect
for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of
0.25mm, the following quantities of material are used depending on the print mode. mm, the following quantities of material are used depending on the print mode. mm, the following quantities of material are used depending on the print mode.
Model info: 30×30×30mm layer thickness: 0.2 Model info: 30×30×30mm layer thickness: 0.25mm
$1.32 72cents
The easiest way to calculate how much material will be used for your model is to use the "Print The easiest way to calculate how much material will be used for your model is to use the "Print The easiest way to calculate how much material will be used for your model is to use the "Print
Preview" option under the "3D Print" menu. This will tell you the total weight of material used, Preview" option under the "3D Print" menu. This will tell you the total weight of material used, Preview" option under the "3D Print" menu. This will tell you the total weight of material used,
including the raft and any support material. including the raft and any suppo
The price as 6/10/12 for ABS plastic from /12 for ABS plastic from
working out to be 0.06 cents per gram. cents per gram.

5. Model Removal

Removal
When the model has finished s finished printing, the printer will beep, and the nozzle and platform stop
heating. Open the door, remove the clips and s Open the door, remove the clips and slide the Perfboard out from the printer platform
Slide the spatula under the model and slowly wiggle it back and forth to pry loose the model. the spatula under the model and slowly wiggle it back and forth to pry loose the model. the spatula under the model and slowly wiggle it back and forth to pry loose the model.
TIP: Remember to use gloves se gloves as the platform and model may still be hot. The spatula is sharp,
gloves must be worn.
UP Plus 3D Printer User Manual 3D Printer User Manual
56cents 51cents
4. Troubleshooting Troubleshooting
and support material. If,
was AU$59 per 1KG was AU$59 per 1KG
nozzle and platform stop
printer platform.
The spatula is sharp,
v 2013.6.10