Table of Contents
Advertisement
4. Load the spool of filament
of filament onto the roll holder, with the
filament coming out from the back of the roll / printer.
filament coming out from the back
5. Feed the end of the filament
Feed the end of the filament through the filament guide.
Feed the filament through the feeder
about 10cm out the other end of the tube.
about 10cm out the other end of the tube.
6. Push the end of the filament into the print head feed
Push the end of the filament into the print head feed
hole.
7. Place the Perfboard
the Perfboard on top of the black platform and
attach the binder clips
attach the binder clips on the front in order to hold the
Perfboard in place. Always remove the Perfboard
printing to remove printed models from the printer.
to remove printed models from the printer.
When printing starts, melted plastic will be pushed into
When printing starts, melted plastic will
the holes of the Perfboard.
the holes of the Perfboard.
8. Plug the USB cable into the
Plug the USB cable into the back right of the printer.
9. Plug in the power adapter
Plug in the power adapter and USB into the back of the
printer.
10. Switch on at the wall socket
Switch on at the wall socket and switch on at the back
of the printer.
11. Visit
www.3dprintingsystems.com/support
www.3dprintingsystems.com/support
and install the 3D Print Software.
and install the 3D Print Soft
12. Installing the drivers (Windows)
Installing the drivers (Windows)
UP Plus 3D Printer User Manual
3D Printer User Manual
through the feeder tube and feed
. Always remove the Perfboard after
to download
Top View
Top View
Chapter 3.1.2 Installing the
3.1.2 Installing the
Chapter 3.1.3 Installing drivers
3.1.3 Installing drivers
v 2013.1.31
.1.31
software
(Windows)
Advertisement
Table of Contents
