Elgar SmartWave SW5250A Operation Manual page 91

The following standard waveforms are provided in the SW Series:
NAME
Clip0 A sine wave with the positive halfcycle clipped at 0V from
50 to 130°
ClipPos A sine wave with the positive halfcycle clipped from
50 to 130°
ClipNeg A sine wave with the positive halfcycle set to a 50%
negative value from 50 to 130°
DC+ Used to operate the SW as a positive DC source
(true rms)
DC- Used to operate the SW as a negative DC source
(true rms)
DcRip03+ +DC with 3% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
DcRip03- -DC with 3% ripple. Frequency of the ripple is determined
by the programmed output frequency (true rms)
DcRip10+ +DC with 10% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
DcRip10- -DC with 10% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
Drop45 Sine with a drop-out above 0V from 45 to 60°
DropNeg Sine with a drop-out to -Vpeak from 4 to 50°
DropPeak Sine wave with drop-out to 0V from 8 to 110°
ExtrnDir DC for use with System External direct input
FlatTp05 Flat-top sine wave with 5% distortion (true rms)
FlatTp10 Flat-top sine wave with 10% distortion (true rms)
Operation Manual
STANDARD WAVEFORMS
DESCRIPTION
SECTION 4
SCALE FREQUENCY
FACTOR RANGE
1.0 40-5000 Hz
1.0 40-5000 Hz
1.0 40-5000 Hz
0.7071 N/A
0.7071 N/A
0.7071 40-5000 Hz
0.7071 40-5000 Hz
0.7071 40-5000 Hz
0.7071 40-5000 Hz
1.0 40-5000 Hz
1.0 40-5000 Hz
1.0 40-5000 Hz
1.0 40-5000 Hz
0.9344 40-5000 Hz
0.8894 40-5000 Hz
4-1