Elgar SmartWave SW5250A Operation Manual page 70

Operation
3.3.7.2 COMM Sub-Menu
The SYSTEM COMM (Communications) sub-menu allows you to:
•
Configure the GPIB address and display remote status.
•
Display firmware version information.
SYSTEM
USER
COMM
EXTERNAL
FAULTS
CONFIG
The DWSB and T&MB fields indicate the internal communication status of the Digital
Waveform Synthesis board and Test and Measurement board. These should always
indicate ON-LINE unless a failure has occurred (T&MB will indicate OFF-LINE if this
option is not present).
COMM Sub-Menu Status and Information Data:
Menu Item
GPIB ADDR
ECDI VER X.XX
DWSB VER X.XX
TMB VER X.XX
BAUD RATE
DWSB
T&MB
3-26
GPIB ADDR
ECDI VER
DWSB VER
TMB VER
BAUD RATE
DWSB
T&MB
Status and Information Line
[select gpib address]
[installed firmware version]
[RS-232 Baud Rate]
[Digital waveform status]
[Test & Measurement status]
SW 5250A•SW 3500A•SW 1750A
OUTPUT [OFF]
25
X.XX
X.XX
X.XX
57600
ON-LINE
ON-LINE
Range/Default Value
Range 1–30
—
Range 300–57600
Default 57600
On-Line/Off-Line
On-Line/Off-Line
Operation Manual