Voltage Dropout Example - Elgar SmartWave SW5250A Operation Manual

Operation
3.5.3

Voltage Dropout Example

This example illustrates programming the SW for a voltage dropout on a 120V sine
waveform that starts at 45° with a duration of 1 millisecond and an amplitude of 10 volts.
MAIN MENU
PROGRAM
MEASURE
WAVEFORM
SEQUENCE
INSTR
SYSTEM
1. At the MAIN MENU, select the WAVEFORM menu, then press <Enter>.
WAVEFORM
LOAD
EDIT
VIEW
SAVE
DELETE
2. The WAVEFORM Menu will default to the LOAD sub-menu. If the cursor is not
pointing to LOAD, use the Knob or Up/Down Arrow keys to select LOAD.
3. Press the Enter key to enter the FUNC (function) mode.
4. Press <Enter> again to place a box around the waveshape selection.
5. Use the Knob to cycle through the waveshape selections until SINE appears in
the FUNC box.
3-42
SW 5250A•SW 3500A•SW 1750A
OUTPUT [OFF]
OUTPUT [OFF]
Operation Manual