Chapter 4 Advanced Settings; Advanced Wireless Settings - Advantech IEEE 802.11a/n Wireless Access Point/ Client Bridge User Manual

Chapter 4 Advanced Settings

Advanced Wireless Settings

Open "Advanced Settings" in "Wireless" to make advanced wireless settings.
Figure 27 Advanced Wireless Settings
A-MPDU/A-MSDU Aggregation
The data rate of your EKI-6331AN except wireless client mode could be enhanced greatly with
this option enabled; however, if your wireless clients don't support A-MPDU/A-MSDU aggregation,
it is not recommended to enable it.
Short GI
Under 802.11n mode, enable it to obtain better data rate if there is no negative compatibility issue.
RTS Threshold
EKI-6331AN sends RTS (Request to Send) frames to certain receiving station and negotiates the
sending of a data frame. After receiving an RTS, that STA responds with a CTS (Clear to Send)
frame to acknowledge the right to start transmission. The setting range is 0 to 2346 in byte.
Setting it too low may result in poor network performance. Leave it at its default of 2346 is
recommended.
EKI-6331AN_User Manual
ƒ‰‡