Basic System Settings - Advantech IEEE 802.11a/n Wireless Access Point/ Client Bridge User Manual

Basic System Settings

For users who use EKI-6331AN for the first time, it is recommended that you begin configuration from
"Basic Settings" in "System" shown below:
Figure 11 Basic System Settings
Basic Settings
Device Name: Specify the device name, which is composed of no more than 15 characters with
(0-9), (A-Z), (a-z) or (-).
Network Mode: Specify the network mode, including Bridge and Router. It is easy to configure
parameters in Bridge Mode; however, users must pay extra attention to the way they configure the
device when it is set to Router Mode.
Ethernet 1 Data Rate: Specify the transmission rate of data of LAN1. Default is Auto.
Ethernet 2 Data Rate: Specify the transmission rate of data of LAN2. Default is Auto.
Country Region: The availability of some specific channels and/or operational frequency bands
are country dependent.
Secondary RJ45 Power: The secondary Ethernet port (labeled LAN 2) is for IP video integration.
To use it you need to enable the secondary port via WEB UI in advance before connecting with
the IP camera.
Spanning Tree: Spanning Tree Protocol (STP) is a link management protocol for AP which
provides path redundancy while preventing loops in a network. STP allows only one active path
at a time between the access points but establish the redundant link as a backup if the initial link
EKI-6331AN_User Manual
ƒ‰‡