Restore Factory Default Settings; Reboot - Advantech IEEE 802.11a/n Wireless Access Point/ Client Bridge User Manual

Restore Factory Default Settings

EKI-6331AN provides two ways to restore the factory default settings:
Restore factory default settings via Web
From "Configuration File", clicking "Reset Settings to Default" will eliminate all current settings
and reboot your device, then default settings are applied.
Figure 37 Restore Settings
Restore factory default settings via Reset Button
If software in EKI-6331AN is unexpectedly crashed and no longer reset the unit via Web, you may
do hardware reset via the reset button. Press and hold the button for at least 5 seconds and then
release it until the PWR LED gives a blink.

Reboot

You can reboot your EKI-6331AN from "Configuration File" in "Management" as below:
Click "Reboot" and hit "Yes" upon the appeared prompt to start reboot process. This takes a few
minutes.
EKI-6331AN_User Manual
ƒ‰‡