Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
3.5.6 Select Language
The Select Language soft key is for future use. If
you press the Select Language soft key, the
following message is displayed.
The message disappears after 2 seconds
3.5.7 Load Defaults
To load the factory set defaults, press the Load Defaults soft key in the
CONFIGURATION menu. This returns the ULTRAKey to the default menu and hard key
configuration embedded in the firmware. This is normally a nominal configuration with
default hard key definitions and no defined menus. However, for custom versions of the
ULTRAKey, the default configuration may be a fully functional configuration that is hard-
coded in the ULTRAKey firmware.
When you press the Load Defaults soft
key, the following message is displayed.
Press Done after reading the screen.
You will be asked if you want to load
default menu and hard key configuration.
Press NO to exit restoring defaults.
Press YES to restore the default
configuration. If you select YES, the system
asks if you want to save the defaults to flash
memory.
When asked to save the defaults to flash
memory:
Press NO to only restore the defaults until you power down the ULTRAKey. This allows
you to work with the default settings, but not permanently change the firmware back to
the default settings.
Select YES to restore the defaults to flash memory.
518750-2960
Rev. F
CAUTION: This action deletes all custom programming
and returns the firmware to all default settings as soon as
'Yes' is pressed.
39
HEMU001007
10/15/04
Advertisement
Table of Contents
