Manage Users - Honeywell HEGSA002 User Manual User Manual

3.5 CONFIG MODE, CONTINUED

3.5.2 Manage Users

Press the Manage Users soft key to add
users, delete users, or change user privileges
or password.
The programming soft keys are the six
buttons on the left side.
The programmed users are displayed in the
two right columns.
NOTE: The ULTK Admin user is for factory use and cannot be deleted. The USER
Admin is the factory defined user with password 1111. This user can be deleted, but
you must create another User ID with Admin privileges, log in as the new user, then
delete USER Admin. If you are logged in as password 1111 (USER Admin), you cannot
delete yourself
Add User – press this soft key to add a new
user
1. Using the touch screen or an AT-keyboard, press the characters (up to 4) to enter
the User ID. Use the up and down arrows on the touch screen to access more keys
(lower case letters, symbols, etc.). To enter numeric values, use the numeric
keypad. To delete characters from the end of the User ID, press the Bksp soft key;
to delete all characters, press the Clear soft key.
2. Press the Enter soft key to enter the
new User ID. The ULTRAKey requires
you to provide a system privilege level -
User, Lead, or Admin.
518750-2960
Rev. F
27 HEMU001007
10/15/04