Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
Change Password – Press the User's soft key (the User key should be outlined), then
press the Change Password soft key. The message, "Are you sure you want to change
the password for User ID?", is displayed. Answer Yes or No. If you answer No, you exit
the change password menu. If you answer Yes, the LCD prompts you to enter the new
password. Enter the new password using the numeric soft keys or the numeric keypad,
then press Enter. The LCD prompts you to confirm the new password, then press Enter.
Save – Press this soft key to save all user entries (new and changed).
Quit – Press this soft key to exit the Manage Users menu.
3.5.3 Config Hard Keys
Press the Config Hard Keys soft key (from
the CONFIGURATION menu) to program the
response for the function (hard) keys.
1. Press the Edit Properties soft key.
2. Press the hard key you want to
configure or change the current
configuration
For example, if you pressed the VCR
hard key, the following menu is
displayed.
You can program the hard key to send a keystroke command to the MXAT200
controller or call up another menu or both. The keystroke command must be
programmed in the MXAT200 using SETMAX.
3. To program one or more (up to 10) keystroke commands, press the MAX Key soft
key. The first key command, step #1, is
displayed.
NOTE: The same procedures used to
program a hard key are used to edit the
configuration of a hard key.
518750-2960
Rev. F
CAUTION: Save new entries and user changes prior to
quitting.
29
HEMU001007
10/15/04
Advertisement
Table of Contents
