Uploading/Downloading Data Files And Custom Settings - Honeywell HEGSA002 User Manual User Manual

Ultrakey controller
Table of Contents

Advertisement

3.5 CONFIG MODE, CONTINUED
10. Left click on Download File in the PC file transfer window.
A counter to show the file transfer is displayed in the PC window.
If you downloaded the operating system file (rom.vxWorks.bin), the message,
"Download of RTOS firmware complete", is displayed on the ULTRAKey when the
download is complete.
If you downloaded the application firmware file (rom.appl.bin), the message,
"Download of Application firmware complete", is displayed on the ULTRAKey when
the download is complete.
After the download is complete, the display on the ULTRAKey returns to the SEND
and RECEIVE Menu.
11. You must power down the ULTRAKey and power it back up to use the new firmware.
Note: If the configuration file is corrupted and the ULTRAKey does not come back
online, refer to paragraph 4.2.1 for booting the ULTRAKey using the factory default
configuration and erasing the configuration data.

3.5.9 Uploading/Downloading Data Files and Custom Settings

The user custom settings and data files can be uploaded to a PC for backup or can be
downloaded from a PC to the ULTRAKey.
The PC must be connected to the ULTRAKey on COM 3 (RS-232 DB-9). The PC must
have the file transfer software loaded and the communication settings of the port on the
PC must be the same as the communication settings of COM 3 on the ULTRAKey. The
recommended transfer baud rate is 38,400. COM 3 on the ULTRAKey must be set for
File Transfer.
1. Set the ULTRAKey port settings for COM3 to File Trans and set the baud rate to the
desired setting. Refer to paragraphs 3.5, 3.5.1, and table 2. Power down the
ULTRAKey and power it back up.
NOTE:
down
518750-2960
Rev. F
WARNING: Make Sure You Have Downloaded Both
Files Before Powering Down Unit. Wait Until The
Download Complete Message Is Displayed Before
Powering Down The Unit. The Flash Memory May
Become Corrupted If Power Is Removed Too Soon
After Downloading Firmware.
If COM3 is already set to File Trans, you do not need to power the unit
44
HEMU001007
10/15/04

Advertisement

Table of Contents
loading

Table of Contents