Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
3.5.9.2
Download Data to ULTRAKey (Receive Any File)
Perform the following procedures to download a file from a PC to the ULTRAKey.
1. Perform steps 1 through 7 in paragraph 3.5.9.
2. Left click on Settings, then left click on
Select Path.
a. Select the Disk on the PC where the
b. Select the Directory (if applicable) where the file is stored. Note: the file can be
c. Left click on OK.
3. Left click on File or press Alt+F on the PC keyboard. Left click on File Transfer.
The disk and directory you selected in step 2 above is displayed. Select the file
you want to download (send) to the ULTRAKey by highlighting it. The location of the
file and the file name is displayed in the Path field.
4. Press the Receive Any File soft key on the ULTRAKey LCD display. The message,
"You have chosen to receive data?", is displayed.
a. Press Yes to continue to receive data. If you press Yes, the message "Ready to
b. Press No to end the file transfer operation.
5. After pressing Yes, Left click on Download File in the PC file transfer window.
A counter to show the file transfer is displayed in the PC window. When the transfer
is complete, the counter window closes.
The ULTRAKey LCD displays a message: RECEIVING DATA. When the transfer is
complete, the message, "Download of setup data file complete", is displayed. The
ULTRAKey display then returns to the Send and Receive Menu.
518750-2960
Rev. F
file you want to send to the
ULTRAKey is located. For example
a: if it is stored on a floppy or c: if it
is stored on a hard drive. The disk
must be highlighted in the window.
stored in the root directory so you may not need to select a directory. The path
you select is displayed in the Path: field.
NOTE: You have approximately one (1) minute to
begin downloading a file after pressing YES before
the unit times out and returns to the Send and
Receive Menu.
Receive Data" is displayed.
49
HEMU001007
10/15/04
Advertisement
Table of Contents
